How To Replace A Window Pane In A Wooden Frame
Have the new glass cut so it measures 1/8 inch shorter than the exact groove dimensions in both the length and width. This creates a 1/16-inch gap on each side between the edges of the pane and the rabbet groove. The gap provides room for the glass to expand when the weather changes.
In improver to the replacement drinking glass pane, you'll need: latex glazing putty; metallic glazing points; pliers; a heat gun; flexible putty pocketknife; ane- or 2-inch, potent, steel, putty knife; and a flathead screwdriver.
Also check out these other articles on replacing broken window panes in: steel-casement windows; sliding-sash windows; and metal storm windows.
Use the pliers to remove all of the glass shards.
When y'all piece of work with cleaved glass, vesture safety goggles as well as gloves; small chips of drinking glass can cause permanent middle impairment.
Utilise the estrus gun to warm the old putty; and so scrape information technology away with a putty knife.
If the putty doesn't elevator off hands, apply more than oestrus and try over again. Be patient — the putty around really old windows is equally difficult as concrete, but it volition soften.
Don't chisel out the old putty — you lot might wreck the window. The putty will soften with plenty heat and time.
Utilize a putty knife or the tip of a screwdriver to remove the sometime glazing points.
The points will be cached under the one-time putty.
Make clean and audit the rabbet groove.
Ensure that no glazing putty, drinking glass shards, or glazing points remain.
Utilise a bead of putty on the glass side of the rabbet groove.
Squeeze out a i⁄xvi-inch bead of putty between the edge of the glass and the window frame.
Gently printing down the glass at the edges to embed the glass into the putty.
Allow the putty to spread out and grade a moisture seal on the inside of the window between the glass and sash.
Position the new pane in the rabbets.
Shift the pane until you have a 1/16-inch gap between the pane and sash on all four sides.
Place at least 2 new glazing points in each section of the window sash surrounding the new glass.
Space the points evenly around the perimeter, about half-dozen inches apart.
Use the flat side of a putty knife to push one corner of each triangular glazing bespeak into the forest sash.
Yous can use a screwdriver bract instead of a putty knife.
Course a 1/2-inch-thick rope of putty and printing the length along all four sides of the glass.
Roll a glob of putty betwixt your bare hands to form the rope.
Smooth the glazing putty and scrape away the excess.
Hold the putty knife at a 45-degree bending, printing, and shine the glazing putty confronting the glass and sash.
Later the putty dries completely, repaint the putty and repaired area.
Don't mask off the glass earlier repainting. The pigment will aid course a wet seal betwixt the glass pane and the sash. Then, allow the paint to overlap about i/8 inch onto the glass.
Almost This Article
This article can be constitute in the category:
- Windows ,
Source: https://www.dummies.com/article/home-auto-hobbies/home-improvement-appliances/windows-home-improvement-appliances/how-to-replace-a-broken-glass-pane-in-a-wood-frame-window-206792/
Posted by: summersares1952.blogspot.com
0 Response to "How To Replace A Window Pane In A Wooden Frame"
Post a Comment